February 2016
 << <Aug 2017> >>


Who's Online?

Member: 0
Visitors: 2

rss Syndication

Posts sent on: 2016-02-01

01 Feb 2016 
To explain all the aspects of the matter we are in need of 2,568,985 web pages and an eternity to write them all therefore this is a short resume of the entire story.

Before you go in details and ask for an offer, you should know two things very well:

First is you need to state the quality degree of the flakes you must have at the end.

Second, only by order, is the known fact you should be prepared to spend a lot of money.

And this is what it means:

For instance a flake, very best for fibres application, may contain 20 PPM of glue and, if this is the quantity, your customer shall be very happy.

The same material with 10 PPM of glue may also be good, after pelletizing and SSP, for bottles application.

Therefore, the difference is 10 PPM add up to 0,001% - Got the point ?

Actually this is simply not the only real difference because, again, the matter is a little bit more complicated, but gives you an idea of what we're talking about.

At the end, the big difference stays also in the price to get one quality versus another.

If you require a bottle to bottle top quality washing line, the quantity you'll read within the last page will never have significantly less than six zeros, and you're lucky if primary number is a 1, while for less quality the number can be shorter, not forgetting the difference in operating costs.

This "small" difference will also effects the composition of the line in other sections.

Sorting, that is the very first portion of the relative line, must be perfect, meaning no PVC, PS, PA or other plastics cannot reach the granulator because following this true stage these plastics cannot be recognized and removed. (yes, it could but is much too expensive)

Then, flakes go to air-separators to eliminate detached labels and plenty of of the dirt, pre-washing, separation simply by sink-float tanks, the cleaning process, rinsing that's is another very important step of the procedure and final drying.

When you got all of this, you're half of the best way to complete the create.

In fact you have flakes clean to the bone with caustic soda solution, detergents and all these good stuff, that's actually pretty easy to feed to the line and, as co extruder a consequence, you need to remove it.

Water filtration is as important because the washing line itself therefore.

An excellent filtration system(s) is what makes the line to perform well, and contain costs, also because in this instance, we are discussing hot water consequently energy costs are involved as well.

Next step is to transform your flakes into very clear pellets upgrading the quality to the very best.

To know more relating to this, go to SSP webpage where is writeen likewise how to avoid the traditional SSP and get the same or better quality without losing weight and obtain it FDA approved.
Admin · 977 views · Leave a comment